Winding On The Wire Pulley - Toshiba e-STUDIO206L Service Manual

[C] Winding on the wire pulley
(1) Pull the ø3 ball terminal [1] located at the
center of the wire into a hole on the wire
pulley. One end of the wire with the hook [2]
attached comes to the outside.
(2) Wind the wires around the wire pulleys of the
front side [3] and rear side [4]. The number of
turns to be wound are as follows: 3 [5]
toward the opposite side (outside) of the
pulley boss, and 3 [6] toward the pulley boss
side (inside).
[7] Black
[8] Silver
Notes:
When winding the wire onto the pulley, be
sure to note the following.
• Do not twist the wire.
• Wind the wires tightly so that they are in
complete contact with the surface of the
pulleys.
• Each turn should be pushed against the
previously wound one so that there is no
space between them.
(3) After winding the wires around the pulleys,
attach the wire holder jigs to prevent the wire
from coming loose.
Notes:
1. When attaching the wire holder jig [1],
make sure that the wire has not shifted or
become loose.
2. The wire should come out of the slot of
the wire holder jig [1] and be passed
under the jig arm [2].
3. When installing the wire holder jig, be
careful of the orientation.
© 2011-2014 TOSHIBA TEC CORPORATION All rights reserved
[3]
[7]
Fig. 4-162
[5]
[4]
[1]
[2]
Fig. 4-163
[1]
Fig. 4-164
e-STUDIO206L/256/306/356/456/506 / 207L/257/307/357/457/507
4 - 57
[6] [5]
[1]
[2]
[6]
[8]
[2]
[1]
DISASSEMBLY AND REPLACEMENT
4