Switch Control Board Srx5K-Scb Specifications; Figure 47: Port Module Srx-Ioc-4Xge-Xfp Serial Number Label - Juniper SRX5800 Hardware Manual

Serial Number Location
Related
Documentation

Switch Control Board SRX5K-SCB Specifications

Copyright © 2015, Juniper Networks, Inc.
The serial number label is located as shown in

Figure 47: Port Module SRX-IOC-4XGE-XFP Serial Number Label

Cards Supported on SRX5400, SRX5600, and SRX5800 Services Gateways on page 35
Flex I/O Card (SRX5K-FPC-IOC) Specifications on page 64
The SRX5K-SCB Switch Control Board (SCB)
following functions:
Powers on and powers off I/O cards (IOCs) and Services Processing Cards (SPCs)
Controls clocking, system resets, and booting
Monitors and controls system functions, including fan speed, board power status, PDM
status and control, and the system front panel
Provides interconnections to all the IOCs within the chassis through the switch fabrics
integrated into the SCB
The services gateways must have at least one SCB installed. On the SRX5600 and
SRX5800 Services Gateways you can install a second SCB for switch fabric redundancy.
When the SCB is part of a host subsystem, the Routing Engine is installed directly into a
slot on the faceplate of the SCB. When the Routing Engine is absent from an SCB, its slot
must be covered by a blank panel.
Chapter 4: Line Card and Module Description
Figure 47 on page
Serial number
ID label
JX0123
(Figure 48 on page
71.
72) performs the
71