Switch Control Board Srx5K-Scb Specifications - Juniper SRX5600 Hardware Manual

Figure 24: SRX5K-SCB
You must install at least one SCB in the services gateway as part of a host subsystem. You can install a
second SCB for redundancy.
The SCBs install horizontally into the slots at the bottom of the card cage labeled 0 and 1. If any slots are
empty, you must install a blank panel.
For detailed information about SCBs supported by the services gateway, see the
SRX5800 Services Gateway Card Reference

Switch Control Board SRX5K-SCB Specifications

The SRX5K-SCB Switch Control Board (SCB)
Powers on and powers off I/O cards (IOCs) and Services Processing Cards (SPCs)
Controls clocking, system resets, and booting
Monitors and controls system functions, including fan speed, board power status, PDM status and
control, and the system front panel
Provides interconnections to all the IOCs within the chassis through the switch fabrics integrated into
the SCB
at www.juniper.net/documentation/.
(Figure 25 on page 66) performs the following functions:
SRX5400, SRX5600, and
65