Perform Engine Maintenance - Perkins Models; Replace The Engine Air Filter Element - Genie ZX-135/70 Service Manual

August 2014
C-3
Perform Engine Maintenance –
Perkins Models
Engine specifications require that this procedure
be performed every 500 hours or annually.
• Engine oil and filter – change
• Fuel system primary filter (water separator)
element – replace
• Fuel system secondary filter – replace
• Crankcase breather (canister) – replace
• Hoses and clamps – inspect/replace
• Radiator – clean
• V-belts - inspect/adjust/replace
Required maintenance procedures and additional
engine information is available in the Perkins
1100D Operation and Maintenance Manual
(Perkins part number SEBU8172-00).
Perkins 1100D Operation and Maintenance Manual
Genie part number
Part No. 218700
Checklist C Procedures
C-4
Replace the Engine Air Filter
Element
Genie specifications require that this procedure be
performed every 500 hours or six months,
whichever comes first.
Maintaining the engine air filter in good condition is
essential to good engine performance and service
life. Failure to perform this procedure can lead to
poor engine performance and component damage.
Note: Perform this procedure with the engine off.
1 Release the latches on the air cleaner cap.
Remove the end cap from the air cleaner
canister.
2 Remove the filter element.
3 Use a damp cloth to wipe the filter sealing
surface and the inside of the outlet tube. Make
sure that all contaminant is removed before
the filter is inserted.
4 Check new filter element gasket for damage
before installing.
123702
5 Install the new filter element.
6 Install the end cap on the canister and secure.
Note: Be sure the discharge slot is pointing down.
ZX-135/70
Service Manual
55