Perform Engine Maintenance - Perkins Models; Replace The Engine Air Filter - Genie S-105 Service Manual

June 2011
REV B
C-3
Perform Engine Maintenance -
Perkins Models
Engine specifications require that this procedure be
performed every 500 hours or 12 months,
whichever comes first.
Proper engine maintenance, following the engine
manufacturer's maintenance schedule, is essential
to good engine performance and service life. Failure
to perform the maintenance procedures can lead to
poor engine performance and component damage.
Required maintenance procedures and additional
engine information are available in the
Perkins 1004 User's Handbook
(Perkins part number TPD 1349E) OR the
Perkins 1100 Series User's Handbook
(Perkins part number TPD 1477).
Perkins 1004 User's Handbook
Genie part number
Perkins 1100 Series User's Handbook
Genie part number
To access the engine:
1 Remove the engine tray retaining fastener
located under the engine tray. Swing the engine
tray out and away from the machine.
2 Install the fastener that was just removed
through the engine tray and into the engine tray
anchor hole in the turntable.
Crushing hazard. Failure to install
the fastener into the engine tray
anchor hole to secure the engine
tray from moving could result in
death or serious injury.
Part No. 102916
Section 3 • Scheduled Maintenance Procedures
C-4

Replace the Engine Air Filter

Element
Engine specifications require that this procedure be
performed every 500 hours or 6 months, whichever
comes first.
Maintaining the engine air filter in good condition is
essential to good engine performance and service
life. Failure to perform this procedure can lead to
poor engine performance and component damage.
Note: Perform this procedure with the engine off.
1 Release the latches on the air cleaner cap.
Remove the end cap from the air cleaner
canister.
2 Remove the filter element.
3 Use a damp cloth to wipe the filter sealing
surface and the inside of the outlet tube. Make
sure that all contaminant is removed before the
61376
filter is inserted.
4 Check new filter element gasket for damage
107526
before installing.
5 Install the new filter element.
6 Install the end cap on the canister and secure.
Note: Be sure the discharge slot is pointing down.
S-100 • S-105 • S-120 • S-125
CHECKLIST C PROCEDURES
3 - 45