Grease The Turntable Rotation Bearing And Rotate Gear; Grease The Extendable Axles - Genie S-105 Service Manual

June 2011
REV B
A-10
Grease the Turntable Rotation
Bearing and Rotate Gear
Genie specifications require that this procedure be
performed every 100 hours of operation. Perform
this procedure more often if dusty conditions exist.
Frequent application of lubrication to the turntable
bearing and rotate gear is essential to good
machine performance and service life. Continued
use of an improperly greased bearing and gear will
result in component damage.
1 Remove the turntable rotation gear cover
retaining fasteners and remove the gear cover
from the machine.
2 Open the ground controls side turntable side
cover.
3 Locate the grease fitting below the ground
control box.
4 Pump grease into the turntable rotation bearing.
Rotate the turntable in increments of 4 to 5
inches (10 to 13 cm) at a time and repeat this
step until the entire bearing has been greased.
5 Apply grease to each tooth of the drive gear,
located under the turntable.
6 Install the turntable rotation gear cover and
retaining fasteners onto the machine.
Bodily injury hazard. Contact with
the turntable rotation gear could
result in serious injury. Do not
operate the machine if the
turntable rotation gear cover is not
installed.
Part No. 102916
Section 3 • Scheduled Maintenance Procedures
A-11

Grease the Extendable Axles

Genie specifications require that this procedure be
performed every 100 hours of operation. Perform
this procedure more often if dusty conditions exist.
Frequent lubrication to the front and rear extendable
axles helps to ensure the smooth operation of the
axles over the lifetime of the product. Two grease
fittings are added at each extending axle. One to
direct grease to the top sliding wear pad and one to
direct grease to the bottom sliding wear pad.
1 Locate the grease fittings on the extendable
axles covers.
S-100 • S-105 • S-120 • S-125
CHECKLIST A PROCEDURES
a Top wear pad grease fitting
b Side wear pad grease fitting
a
b
3 - 13