Grease The Turntable Rotation Bearing And Rotate Gear; Perform Engine Maintenance - Honda Models (If Equipped) - Genie TMZ-50/30 Service Manual

Section 3 • Scheduled Maintenance Procedures
800-610-4101
ActionRental.com
CHECKLIST A PROCEDURES
A-13
Grease the Turntable Rotation
Bearing and Rotate Gear
Genie specifications require that
this procedure be performed every
100 hours of operation.
Regular application of lubrication to the turntable
bearing and rotate gear is essential to good
machine performance and service life. Continued
use of an insufficiently greased bearing and gear
will result in component damage.
1 Locate the grease fitting on the inside of the
turntable rotation bearing.
The grease fitting is best located
through the bulkhead opening
behind the function manifold.
a
b
2 Pump grease into the turntable rotation bearing.
Rotate the turntable in increments of 4 to 5
inches / 10 to 13 cm at a time and repeat this
step until the entire bearing has been greased.
3 Apply grease to each tooth of the drive gear
located under the turntable.
Grease Specification
Chevron Ultra-duty grease, EP NLGI 2 (lithium based)
or equivalent
3 - 12
zerk fitting
rotate bearing
A-14
Perform Engine Maintenance -
Honda Models (if equipped)
Engine specifications require
that this procedure be performed
every 100 hours or semi-annually,
whichever comes first. Perform
this procedure more often if dusty
conditions exist.
Proper engine maintenance, following the engine
manufacturer's maintenance schedule, is essential
to good engine performance and service life.
Failure to perform the maintenance procedures
can lead to poor engine performance and
component damage.
Required maintenance procedures and additional
engine information is available in the Honda
a
GX340 Engine Owner Manual
(Honda part number 31ZH9603).
Honda GX340 Owner's Manual
Genie part number
b
TMZ-50/30
June 2005
REV B
97361
Part No. 65162