Perform Engine Maintenance - Kubota Models; Grease The Turntable Rotation Bearing And Worm Drive Gear - Genie Z-34/22IC Service Manual

Section 3 • Scheduled Maintenance Procedures
CHECKLIST A PROCEDURES
A-9
Perform Engine Maintenance -
Kubota Models
Note: Engine specifications require that this
procedure be performed every 100 hours.
Required maintenance procedures and additional
engine information is available in the
Kubota D905 Operator's Manual
(Kubota part number 16622-8916-5) OR the
Kubota DF752 Operator's Manual
(Kubota part number EG601-8916-1).
Kubota D905 Operator's Manual
Genie part number
Kubota DF752 Operator's Manual
Genie part number
3 - 12
A-10
Grease the Turntable Rotation
Bearing and Worm Drive Gear
Note: Genie specifications require that this
procedure be performed every 100 hours.
Yearly application of lubrication to the turntable
bearing and worm drive gear is essential to good
machine performance and service life. Continued
use of an improperly greased gear will result in
component damage.
1 Raise the secondary boom and place a safety
chock on the secondary boom lift cylinder.
Carefully lower the boom onto the lift cylinder
31743
safety chock.
84250
Note: The lift cylinder safety chock is available
through Genie Service Parts (part number 36555).
2 Locate the grease fitting on the inside of the
bearing in the middle of the turntable.
3 Pump grease into the turntable rotation bearing.
Rotate the turntable in increments of 4 to 5
inches / 10 to 13 cm at a time and repeat this
step until the entire bearing has been greased.
4 Remove the safety chock. Lower the boom to
the stowed position.
Z-34/22 IC
Crushing hazard. Keep hands
away from the cylinder and all
moving parts when lowering the
secondary boom.
Part No. 128267
July 2007
REV A