Adjusting The Punch Hole Position In The Vertical Direction - Konica Minolta BIZHUB 501 Service Manual

3. MECHANICAL ADJUSTMENT
3.2

Adjusting the punch hole position in the vertical direction

A. Procedure
24
[1]
4521f3c004na
Field Service Ver.1.0 May. 2008
1. Set the punch hole mode, and make a copy in the
single sided original -> single sided print mode.
2.
Fold the copy exited into two and check the posi-
tion of the punch holes to see if the discrepancy
"A" [1] is 2 mm or less.
3.
When "A" is in excess of 2 mm, adjust the punch
hole position in the vertical direction.