Konica Minolta BIZHUB 501 Service Manual page 682

Field Service Ver.1.0 May. 2008
Precaution for Clincher Reinstallation
• When the Clincher is installed, the position of the Stapler and the Clincher will be
misaligned. Be sure to perform the following adjustment.
[2]
[3]
[6]
[7]
[1]
4511f2c030na
[3]
[4]
4511f2c031na
[6]
[5]
4511f2c032na
[9]
[8]
4511f2c033na
1. Install the Stapler, and then install the
Staple Cartridge.
2. Use three screws [1] to temporary fix
the Clincher [2].
3. Loosen three screws [3] of the stopper.
4. Loosen three screws [4] of the Clincher.
5. Aligning the protrusions of the jig [6]
with the recesses in the Stapler [5], fit
the jig to the Stapler.
NOTE
• Make sure that the protrusions of the
jig properly rest in the recesses.
6. Turn the gear [7] of the Clincher to
project the protrusions [9] of the
Clincher, and then slide to put into the
Clincher as it fits into the recesses [8] of
the jig.
3. OTHER
13