Lift Tray; Conveyance Unit - Konica Minolta BIZHUB 501 Service Manual

Field Service Ver.1.0 May. 2008
3.3.9

Lift Tray

NOTE
• When removing the Lift Tray, be sure to bring the Tray down to the bottom in advance.
• If the OT is installed, remove it in advance.
[1]
[2]
[4]
[3]
3.3.10

Conveyance Unit

[2]
1. Remove the Front Door.
[1]
(See P.10)
2. Remove the Conveyance Front Cover
/Lt.
(See P.10)
3. Disconnect three connectors [1].
4. Remove two screws [2], and remove the
ground wire.
4349f2c019na
5. Remove the Tray /1, Tray /2 and OT.
(See P.12)
6. Remove six screws [3], and lift the Lift
Tray [4] upward and off from the Con-
veyance Unit.
NOTE
• The removal of the upper 2 screws [3]
[3]
is not available when the Lift Tray is
not brought down to the bottom.
7. Reinstall the above parts following the
4349f2c020na
removal steps in reverse.
1. Remove the Lift Tray.
(See P.13)
2. While holding down the lock release
button [1], remove the Conveyance Unit
[2].
3. Reinstall the above parts following the
[1]
removal steps in reverse.
4349f2c021na
3. OTHER
13