Konica Minolta BIZHUB 501 Service Manual page 647

3. MECHANICAL ADJUSTMENT
3.1.2 Output check mode
A. Setting of the output check mode.
(1) Procedure for setting
Note
• Before executing the output check mode, be sure to remove the upper cover, the front cover /Up
and the rear cover of FS in advance.
(See P.6, P.8, P.10)
• When removing the covers of FS, be sure to block the light that strikes on the front door sensor
(PS17) and the upper door sensor (PS18).
[1]
18
1. Turn OFF the power switch (SW2) of the main
body.
2.
Switch the test switch [1] to the output check
mode.
(See P.19)
3.
Turn ON SW2.
4.
The output check mode is set.
4521f3c002na
Field Service Ver.1.0 May. 2008