Adjusting The Hole-Punching Positions (Punch Vertical Position) - Konica Minolta bizhub 750 Copy Manual

Utility
Note
Enter the value by mm using the keypad. Refer to the conversion rate be-
low. 1 in. = 25.4 mm

Adjusting the Hole-Punching Positions (Punch Vertical Position)

When PK-505 is installed, the vertical position of the punched holes can be
adjusted.
0 Use the "Punch" function to print a single sample copy, and then perform
the adjustment while checking the sample that was created.
1
Display the Administrator Setting screen.
– For details on displaying the Administrator Setting screen, refer to
"Displaying the Administrator Setting Screen" on page 12-39.
2
Touch [1 System Setting].
The System Setting screen appears.
3
Touch [7 Expert Adjustment].
The Expert Adjustment screen appears.
4
Touch [5 Finisher Adjustment].
The Finisher Adjustment screen appears.
5
Touch [3 Punch Adjustment].
The Punch Adjustment screen appears.
6
Touch [1 Punch Vertical Position].
The Punch Vertical Position screen appears.
bizhub 750/600
12
12-49