Adjustment/Setting; Mechanical Adjustment; Fold Skew Adjustment - Konica Minolta BIZHUB 501 Service Manual

Field Service Ver.1.0 May. 2008

ADJUSTMENT/SETTING

4.

MECHANICAL ADJUSTMENT

4.1

Fold Skew Adjustment

NOTE
Make this adjustment after any of the following procedures has been performed.
• When the Folding Unit has been replaced.
• When skew occurs in the crease.
1. Enter the Half-fold mode and make a copy. (A3 or 11 x 17 Size)
[3]
A
[1]
[2]
4511f3c001na
[4]
4511f3c002na
4. MECHANICAL ADJUSTMENT
2. Fold the output paper along the crease
[2].
3. Fold the output paper and measure the
width A of the paper.
Specification: 0 ± 1.5 mm
4. If the fold position is skewed as shown
on the left, make the following adjust-
ment.
[1] Center
[2] Crease
[3] Exit direction
5. Open the Front Door, loosen the adjust-
ment screw [4], and move the Folding
Unit to the left to make the adjustment.
Graduated in 1 mm divisions
• If the fold position is skewed opposite to
the figure of step 4, move the Folding Unit
to the right to make the adjustment.
6. Make another copy and check the fold
position.
29