Konica Minolta BIZHUB 501 Service Manual page 581

2. PERIODIC CHECK
[8]
[7] [9] [5]
[4] [2]
6
[5] [6]
[2]
[4] [3] [1]
16aaf2c003nb
[3]
[1]
16aaf2c004na
Field Service Ver.1.0 May. 2008
4.
Remove the C-clip [1] and then remove the actua-
tor [2].
5.
Remove the C-clip [3] and then remove the bear-
ing [4].
6.
Release the claws [6] of the bearings [5], two
each, and then remove the two bearings [5].
7.
Pull out the shaft [7] in the arrow-marked direction
[8] and remove the feed roller [9].
8.
Remove the feed rubber [2] from the paper feed
roller [1].
Note
• Be sure to install the feed rubber [2] so that
the paint mark [3] comes in the opposite
direction of the gear [4].
• When setting the feed rubber, apply alcohol
on the inside of the feed rubber. By doing so,
the feed rubber can be set more easily.