Konica Minolta BIZHUB 501 Service Manual page 326

Field Service Ver.2.0 Mar. 2009
*
32 Set the resolution when using the Scan To HDD
Set the converting resolution of the scanner.
Note
• When set to "0", the image is converted at the res-
olution specified with the press panel. However
with the default setting (200dpi), the performance
speed is high but the image quality is degrated.
• When set to "1", the image is scanned at 600dpi.
• When set to "1", the resolution is converted with
the software so that the performance speed is
slowed down.
*33 Setting for supporting of MediaType command
of Emperor
The countermeasure for the trouble that the A3 dou-
ble-sided printing job is not performed nomally when
orderd by PCL5.
This is default setting to prevent the trouble.
Note
• When "1" is selected for this setting, Media Type is
supported but print abnormality may occur.
*34
DIPSW 40 is the setting of WakeOnLan function.
*35 Wake-up by the recovery of the link change
It wakes up when the LAN cable is connected and the LED on the LAN connecting port turns ON.
(In case that the LAN cable is connected to be ready to communicate.)
*36 Wake-up by receiving magic packet
It wakes up when receiving the magic packet that is sent from the software with Wake On Lan function.
(In case of receiving a particular packet communication via network.)
*37 Wake-up by receiving multi cast packet
It wakes up when receiving the broad cast packet (concurrent transmission that specifies the multi communica-
tion partners) that is sent from PC or the network device.
(In case of receiving a particular packet communication via network.)
*38 Wake-up by receiving broadcast packet
It wakes up when receiving the broad cast packet (concurrent transmission to the unspecified number of com-
munication partners) that is sent from PC or the network device.
(In case of receiving a particular packet communication via network.)
Mode
Specify the resolution when scanning
Convert the resolution with software
after scanning
Mode
Not support setting of Media Type.
Support setting of Media Type.
10. SERVICE MODE
39-5
0
1
39-7
0
1
289
1