Konica Minolta BIZHUB 501 Service Manual page 324

Field Service Ver.2.0 Mar. 2009
*22 Operation improvement when the control unit
(CU-1) is installed
When the control unit (CU-1) is installed and the doc-
ument from the personal user box is used, the docu-
ment can be deleted at the same time as printing if
the print setting is not needed.
*23 Custom original support
Set when copying custom originals.
*24 Address release setting after sending through
the scanner
Set whether to release the address and the settings
or not after scanning/faxing.
When setting it to "1", the address and the settings
are stored without a display of pop-up.
*25 Fusing temperature setting while in the selection
of plain paper
When there occurs a problem (insufficient fusing,
large paper curl) with fusibility while in the selection of
plain paper, change the fusing set temperature.
• Countermeasure
1) Increase the temperature: To suppress a jam
due to an insufficient fusing and the wind-up of
paper around the roller.
2) Decrease the temperature: To suppress a
paper curl and the undulation of paper.
*26 Fusing temperature setting while in the selection
of thick paper, envelope, label.
When there occurs a problem (insufficient fusing) with
fusibility while in the selection of thick paper, envelope
and label, change the fusing set temperature. (For
countermeasure, see *25.)
Mode
Normal operation
Personal user box appears first and
"Delete after print" or "Not delete after
print" can be selected when selecting
document.
Mode
Does not support cus-
tom originals
Custom original mode
Custom original size AMS
(center zoom)
Not allowed
Mode
Release
Not release/No pop-up
Mode
Standard
Standard + 10 °C
Standard + 5 °C
Standard – 10 °C
Mode
Standard
Standard + 10 °C
10. SERVICE MODE
34-7
0
1
35-1 35-0
0 0
0 1
1 0
1 1
35-6
0
1
36-3 36-2
0 0
0 1
1 0
1 1
36-4
0
1
287
1