Konica Minolta BIZHUB 501 Service Manual page 762

Field Service Ver.1.0 Mar. 2009
C. List of processing performed when boards of another machine are remounted during board
replacement procedure
• Remounting boards of machine B on machine A
Machine A
Request code is
not generated.
Request code is
generated.
Request code is
not registered in
LMS.
Request code is
generated.
Request code is
registered in LMS.
*1: The following are the prerequisites;
The settings (serial number, etc.) of the i-Option machine, on which the boards are remounted, differ from
those of the i-Option machine, from which the boards are removed.
Machine B
Request code is not gen-
erated in machine B
(same as new board)
NVRAM CF card both
no no no
action action action
Initialize Initialize no
action
Restore Restore Initialize Initialize Initialize Initialize
Request code is generated
in machine B
NVRAM CF card both
Initialize Initialize Initialize
*1
Initialize Initialize Initialize
*1
*1
4. Troubleshooting of i-Option
Remarks:
Specific cases of machine A
• The firmware for i-Option
is installed to the non i-
Option machine but the
request code is not gen-
erated.
• The firmware for i-Option
is installed to the
machine shipped as a
non i-Option machine
and the request code is
generated.
• The machine is shipped
as an i-Option machine.
23