Printing Format; Programming Automatic Range-Shift Printing - Omega RD2800 Series User Manual

14. PRINTING FORMAT

This programming display only appears for the
printing format (option). This programming is to
change the trace printing range automatically.
1
Automatic Range-shift
The automatic range-shift function changes
the trace printing range up to 5 stages
according to the measured values.
(1) This programming can be applied to each
channel.
(2) The total printing
programmed optionally irrespective of the
programmed range in the [Range/Printing
range].
(3) For each range, refer to the minimum
printing range in section 22.1 (Input
Specifications). The printing may be
dispersed if each range is programmed to
be less than the minimum printing range.
(4) The range shifting is executed when the
measured value exceeds approx. 0.5 mm
from the minimum (zero) or the maximum
(span) range.
2
Programming Mode
1) Screen 1 (Printing format check)
   
Automatic
Standard
range-shift
Dots appear at the selected format.
SET
By pressing , the dots disappear and the
END
cursor appears instead.
2) Screen 2 (Programming channel)
Automatic range selection
 
Channel Cursor
By selecting automatic range-shift (  ), the cursor
appears at the channel programming position.
14.1
Total printing
range can be
Mark
the order of programming. By pressing
programming ends, the screen moves to the next
programming screen. As No. 5 is not used in this example,
only press
 
Zone
Compressed/expanded
－９２－

Programming Automatic Range-Shift Printing

<Example> Automatic range-shift programming
<Range No. 23 (K thermocouple)>
Measuring value
-200
1st range
(R1)
-
100 400
range
(1)
Printing range
for 1st range
-100
Printing range
for 2nd range
(400)
Printing range
for 3rd range
(600)
Printing range
for 4th range
(800)
is the programming point and No. (1) to (5) shows
.
ENTRY
3) Screen 3 (Zero programming at No.1 range)
Range No.
  
(1) The default programmed value is the minimum
value in the [Range/Printing range]. This
programming can be changed as required.
(2) When all programming are completed, return to
the above display and execute [Storing].
4) Screen 4 (Span programming at No. 1 to 5
ranges)
Range No.
  

(1) When the programming a span, the range
number advances. Program the span up to the
required range number.
(2) After pressing
ENTRY
again to return to Display 3.
ENTRY
1370
2nd 3rd
4th range
range
range
(R2) (R3) (R4)
600
800 1200
(2)
400
(3)
600
(4)
800
(5)
1200
when the
ENTRY
Zero
 
Programming value
(Max. 5 digits by left-justify)
Span
 
Programming value
(Max. 5 digits by left-justify)
up to range No.5, press