Engineering Units - Omega RD2800 Series User Manual

11. OTHER PROGRAMMING
Engineering units up to 5 digits can be assigned for digital data printing and scale printing.
3
Press and
SHIFT
UNIT
(Digital data printing)
1
In case no engineering unit is programmed;
An engineering unit is decided by the range number programmed in the [Range/Printing range] programming.
Voltage range
mV V
(01 to 05) (06 to 10)
2
Programming Mode


(Fixed)
*1
*1: Engineering unit character
The character at the digit where the digit number is pointed by the cursor is displayed.
*2: Digit No. of engineering unit character
A digit No. 1 to 5 is displayed by pressing
<To decrease the digit No.>
Press and
SHIFT
new digit No.
If the range No. is changed;
A programmed engineering unit is deleted and
the engineering unit determined by the range
No. is displayed
simultaneously to display [Engineering unit] programming screen.
Examples of engineering unit printing 単位印字の例
(Scale printing)
Temperature range
°C
(Nos. other than ones
shown on the right)
 
Digit No. of engineering unit character *2
(Up to 5 digits.)
(Numeric numbers (1 to 5) appear for the digit not programmed by pressing
0
simultaneously to clear the digit No. and press
CLEAR
－６９－

11.8 Engineering Units

K
(47, 80)
.
°F
If clear is stored at scale programming;
If the scale is cleared in a channel; the
engineering unit of this channel is deleted, and it
becomes the engineering unit determined by
range No.
(List printing)
°F
for reprogramming a
°F
.)