Programming 3 Chart Speeds - Omega RD2800 Series User Manual

13. REMOTE CONTACTS
The "3 chart speeds" programming screen appears only in the remote contacts (option).
1
Press and
SHIFT
CHART
speeds (CS1 to 3) and select the desired speed with a contact signal. See section 13.1
3
Programming Mode


Speed
Unit for the
Cursor
No.
speed
4
Programming Flow Chart
<Example> From 20 mm/h to 40 mm/h for CS2
Operation screen
[Check]
  
Speed unit Speed No.
[To be ready for programming]
  
Cursor
[Selecting CS No.]
  
Speed No.
[Selecting speed]
  
YES
Error display appears?
Any key other
than
SHIFT
Programming other Nos.?
YES
simultaneously to display the "3 chart speeds" programming screen. Program 3 chart

Chart speed
(4 digits programming)
1
＋
SHIFT
CHART
SET
END
/ %
0 0
CLEAR CLEAR
ENTRY
NO
Temporarily stored
NO
SET
＋
SHIFT
END
Stored
Ref. 3
－９０－

13.3 Programming 3 Chart Speeds

Default: 20 (RD200), 25 (RD2800)
Programming range: 0001 to 0600
(mm/h) or 0001 to 0200 (mm/min.)
DISP
0000mm/h can be set for RD2800.
When 0000mm/h is set, chart is fed at
Ref. 1
the speed of 12.5mm/h.
Remarks 1
Ref. 2
All printings except time line, digital
data
change mark will not be executed.
See Section 10.1.
→
°F
Remarks 2
If the chart speed is changed, the
4 0
parameters
SCALE
CLEAR
[Periodic data printing] (Section 11.7)
is cleared.
Reference 1
Press
No. Chart speeds can be checked.
Reference 2
Place the cursor on the character
display (left digit) and press
%
Reference 3
Store the [temporarily stored] parameters
into memory. (Programming change mark
is printed.)
2 .
Defaults parameters and
programming range
If the chart speed is
programmed at 151 mm/h
or faster;
printing and programming
Influence to periodic
data printing
programmed in
Other speed No. check
or to change CS
/
%
Changing the speed
unit (h/min.)
/
to switch [M] and [H] alternately.
Storing
the
or