Programming Procedures - Omega RD2800 Series User Manual

7. PROGRAMMING
This section explains the basic programming parameters.
1
Basic of Programming Flow Chart
Operation screen
(
Measured value/clock/alarm
Programmed parameter check
Ready for programming
Programming
by using numeric values or
parameters selection
YES
Same programming for all
channels?
NO
(Programming for
each channel)
Temporarily stored
Programming other channels?
NO
ENTRY (Note)
Stored
Programming same parameter to
Reference
other channels
Use [copy] function for convenient operation.
See Section 11. 14.
2
Key Operation
1) Numeric keys and cursor
• Cursor shifts rightward when pressing numeric
0 9
keys ( to
CLEAR LIST
• Press
or
°F °C

7.4 Programming Procedures

DISP
)
3 sec. or
（ ＋ ）
more
SET
END
Function
keys
ENTRY
YES
Reference
+
SET
SHIFT
END
－
and ).
(-)
for moving the cursor.
－３７－
Programming is interrupted to return to the operation
screen at any programming stage by pressing
key before storing.
Keys to be pressed depending on programming items.
This action is necessary for some programming items.
For parameters to be programmed for each channel,
check the programmed parameters of other channels
with or
/ %
(1) Programming lamp lights.
(2) The cursor appears at a
programmable digit.
Programming lamp

Memory colon
Character display (Abbreviation
of a programming item)
If this procedure is omitted, programmed parameters
are not stored into memory.
(Note) Common programmed parameters are
stored only by pressing
(1) Memory colon starts blinking.
(2) Programming change mark
Programmed parameter (including temporarily
stored programmed parameters) are stored.
During this storing operation, measurement is
interrupted.
* The change mark is printed on the right side of chart
paper. However the
completely until the chart paper advances several
lines.
2) How to add or delete a decimal point
• To add the decimal point move the cursor to
and press
CLOCK
decimal point, press
SPACE
COPY(=)
also deleted.)
3) Clearing a displayed programmed parameter
• The programmed parameter is cleared by
pressing and
SHIFT
DISP
.

Cursor
key.
ENTRY
is printed.*
mark will not be printed
. To delete the
. (Numeric vallue is
0
simultaneously.
CLEAR