11. OTHER PROGRAMMING
This programming is for digital printing (data printing) at fixed intervals. The printing overlaps with trace printing.
5
Press
and
SHIFT
DATA I
programming of parameters for the periodic data printing, the periodic data printing is not executed.
1
Periodic Data Printing
(1) Program start time and interval time.
(2) The printing format with a chart speed of 99 mm/h or
slower is shown below.
<Example> 18:30
Time
2
Programming Mode
(Fixed)
Hour
Minute
Interval time
3
Programming Flow Chart
<Example> Periodic data printing with a start time of 12:00 and
interval time of 4 hours
Operation screen
[Check]
[To be ready for programming]
Cursor
[Programming interval time]
Interval time
[Programming start time]
YES
Error message appears?
Any key other
than
SHIFT
simultaneously to display [Periodic data printing] screen. As the default is no
1: 225°C
2: 316°C
5
+
SHIFT
DATA I
SET
END
0
4
→
SCALE
CLEAR
0
0
→
CLEAR
CLEAR
1
2
→
CHART
TAG
0
0
→
CLEAR
CLEAR
Start time
ENTRY
NO
Stored
-68-
11.7Periodic Data Printing
An example of periodic data printing
<Chart paper speed: 100 mm/h or faster>
(Fixed)
Minute
Hour
Start time
Remarks 1
It depends on the chart speed and
number of printing lines.
T (Min.) ≧
(Note) However, T is 5 minutes or more.
DISP
*1: When 3-speed is programmed by
the remote contacts (option), the
slowest speed is applied.
*2: Depending on the chart speed
and number of channels.
Chart speed
99 mm/h or slower
100 mm/h or faster
→
Remarks 2
Press
SHIFT
simultaneously to clear and carry out
[store].
→
Remarks 3
The programmed values in the [Periodic
data printing] are cleared and the
periodic data printing stops. Reprogram
it if necessary.
Remarks 4
In case electric power failure occurs and
the power is turned on in the following
day, reprogramming is required if
not an integer. (T: Interval time)
(RD200)
Shortest time of interval time (T)
180 x number of printing lines*
Chart speed *1
CH1
CH2 CH3 CH4
1 line
2 lines
1 line 2 lines 3 lines 4 lines
To program periodic data
printing to "none"
0
and
CLEAR
When the chart speed is changed;
From power off to on
24
T is