Remote Contacts Functions - Omega RD2800 Series User Manual

13. REMOTE CONTACTS
Functions
(3) Execution of message printing
(No.1 and 2)
(4) Execution of digital data
printing
(5) Execution of list printing
(List 1, 2, 3)
(6) Execution of operation record
(No. A to D)
(7) Reset of totallization
Warning
Contact signal to terminals
For the contact signal applied to the remote contacts terminals, use a switch or a relay driven at 30V AC or
less or 60V DC or less or a manual contact for a very light load.

13.1 Remote Contacts Functions

Contact signal at terminal
• Program messages first. See Section 11.10.
Message
No.1 OFF
No.2
* When the trigger signals is sent (for 1 sec. or more) after selecting the
message No., the printing of programmed message starts.
(Note) Program "Printing on/off" to on with a key operation in advance.
Execution of message printing with key operation is also available.
See section 9.4.
Turn on (for 1 second or more) the terminal No. which the digital data
printing is allocated.
(Note 1) Program "Printing on/off" to on with a key operation in advance.
Execution of message printing with key operation is also available.
See Section 9.2.
(Note 2) During execution, retry of the
execution can be accepted just
once.
Turn on (for 1 sec. or more) the terminal No. which the printing of list 1, 2 or
3 is allocated.
(Note) Program "Printing on/off" to on with a key
operation in advance. Execution of
message printing with key operation is
also available. See Section 9.3.
Programming of the operation record position is necessary.
See Section 13.4.
Turn on (for 1 sec. or more) the terminal
No. which the operation record (No. A to
D) is allocated. During ON time, the
recording position shifts to 5 mm to the
right from the programmed operation
record position.
(Note) Program "Printing on/off" to
on with a key operation in
advance.
Available in "Totalization" (option). The
totalized value can be reset at an interval time
programmed. It can be reset with a contact
signal, too.
－８８－
ON: Short OFF: Open
COM
EX1 EX2*
For trigger
ON
1 sec. or more
Operation record position
(10 to 90%)
1 sec. or more
1 sec. or more
ON time
ON time
5 mm
1 sec. or more