11. OTHER PROGRAMMING
The channel where the temperature range is programmed becomes effective. Press
simultaneously in the operation screen for 3 seconds or more to display the [Burnout] programming screen. This
programming is necessary for each channel.
1
Burnout
• If a sensor (thermocouple or resistance
thermometer) is disconnected, trace printing
overshoots maximum or minimum limit.
• The default parameter of burnout is "disable"
( ) in all channels.
2
Programmed Flow Chart
<Example> From burnout "disable" to "up scale burnout"
Operation screen
[Check]
Channel
[To be ready for programming]
Cursor
[Specifying channel]
Cursor
[Selecting burnout]
Cursor
YES
Programming other channels?
SHIFT
(
+
3 sec. or more
SET
END
2
TAG
Press several times.
/
ENTRY
Temporarily stored
NO
SET
+
SHIFT
END
Stored
Ref. 3
-75-
11.11 Burnout
Burnout selection menu
Burnout can be selected for each channel out of 3
types shown below.
(Non)
(UP
(down burn)
Remarks 1
DISP
A
parallel
thermocouple with other instrument
)
%
causes a problem. Select ( ) if
Ref. 2
your recorder uses the thermocouple
being
instrument.
Remarks 2
Even if the burnout is programmed to
a channel where the voltage range
(No. 01 to 07) is programmed, this
programming
(burnout disable).
Reference 1
For the burnout operation (display and
printing), read Section 10.2.
Reference 2
Press
channels. The programmed burnout of
other channels can be checked.
Reference 3
Store
parameters
(Programming
printed.)
and
SHIFT
%
: Burnout disable
: Up scale burnout
burn)
:
Down scale burnout
"" programming on
parallel operation
connection
of
connected
with
other
Voltage range is ineffective
becomes
ineffective
Burnout operation
Other channels check
or
to change
/
%
Storing
the
[temporarily
stored]
into
memory.
change
mark
a
is