Omega RD2800 Series User Manual page 28

5. INSTALLATION
3 Chart Paper Setting
1) Draw out the chart paper approx. 50 cm and
close the rear stripper plate.
2) Set the holes on chart paper over the sprockets at
both ends of the drum.
3) Use the thumb wheel to advance the chart paper
for 2 to 3 folds into the chart tray.
4) Close the front chart paper guide. Make sure that
the holes are set over the sprockets.
○
Set the holes of the chart paper on the sprockets.
Remarks Chart paper folds
The mark for fold thread parts and the
mark for fold valley parts are printed on both
ends of the chart paper.
Don't insert the chart paper folds the wrong
way when inserting the chart paper into the
chart paper tray, otherwise a folding failure
will result.
凸
mark (Fold thread)
凸
mark
Chart paper
No.
Time scale
凹 mark (Fold valley)
5.2 Chart Paper Loading (RD2800)
×
凹
mark
Chart paper
－２４－
4 Check
1) Manual check
Turn the thumb wheel by hand to make sure that
the chart paper is feeding properly.
Turning direction of the thumb wheel
Remarks
Don't turn the thumb wheel inward. The chart
paper cannot be fed backward. This action
may cause a chart feed failure.
Thumb wheel
2) Place the chart paper cassette in its the original
position
Guide rails for the chart paper cassette are located
on the right and left side of the internal unit. Set the
guides of the chart paper cassette to the guide
rails and push it until it clicks into place.
3) Chart paper feeding check
(1) Turn on the power supply.
(2) Press the key and check that chart
FEED
paper feeds smoothly.
(3) Repeat the above procedure if the chart paper
is not fed smoothly.
4) Operation during chart paper end detection
When the chart paper cassette is returned in the
internal unit during the chart end detection, the
CHART END display blinks. Press
it from blinking to steady lighting.
ENTRY
Press again. The CHARD END display
goes out and the chart paper is fed automatically.
.
to turn
ENTRY