Message Printing - Omega RD2800 Series User Manual

9. PRINTING
For printing of a pre-programmed message, select the message No. and press
Operation screen
（
[No. selection]
   
Message No.
ENTRY
Message printing starts.
YES*
Interrupt?
REC
ON/OFF
NO
→
ENTRY
Message printing ends.
* With this procedure, the printing operation turns
REC
off. Press and then press
ON/OFF
to turn it on.
Message printing cannot be executed
Remarks
in the following conditions
(1) RECORD ON status lamp is not lit.
(2) KEY LOCK
status lamp lights.
(3) For the chart speed programmed at 150
mm/h or faster
Execution with external
Reference
contact signal
When the remote contacts (option) is added,
message printing can also be executed by a
contact signal. However, this requires the
programming of the "terminal allocation". See
Section 13.2 for details.

9.4 Message Printing

DISP
0 6
＋ ）
CLEAR A - Z
3 sec. or more
(1)
or
/ %
(2)
(3)
(4)
(5)
ENTRY again
.
－５０－
ENTRY
6
0
(1) Press and
A - Z
CLEAR
seconds or more.
(2) Select the message No. (1 to 5) to be printed with
or .
%
/
(Note) Refer to Section 11.10 for programming of
message.
(3) Press to start "Message" printing with a
ENTRY
plotter pen on the right side of the chart paper.
(Note) The "message" will not be printed completely
until the chart paper forwards several lines.
(4) For interrupting the printing, press
press . The printing operation is turned off
ENTRY
and your recorder returns to the normal operation.
For turning on the printing operation, press
and simultaneously again.
ENTRY
(5) When the message printing completes, your
recorder returns to the normal operation.
Example of message printing
(Note) The above example is for RD200. It is the same for
RD2800.
.
simultaneously for 3
REC
and then
ON/OFF
REC
ON/OFF