Remote Contacts; Remote Contacts Functions - Omega RD2800 Series User Manual

13. REMOTE CONTACTS

This explanation is only for the remote contacts (option).
1
Remote Contacts
(1) The following functions are available with the contact
signals at remote contacts terminals (EX1 to 4). However,
the functions are limited due to four terminals (EX1 to 4)
provided. Moreover, some functions are automatically
allocated to a certain terminal Nos.
(2) Programming to allocate the functions to terminal Nos. is
necessary.
Functions
(1) Printing on/off and selection of three chart
speeds
(2) Execution of message printing (No.1 to 5)
(3) Execution of message printing (No.1 and 2)
(4) Execution of digital data printing
(5) Execution of list printing (list 1, 2, 3)
(6) Execution of operation record (No.A to D)
(7) Reset of totallization
(Note 1) Free terminals left are EX3 and EX4.
(Note 2) No free terminals are left.
(Note 3) Free terminals left are EX3 and EX4.
2
Functions and Terminal Contact Signals
Functions
(1) Printing on/off and selection of
3 chart speeds
(2) Execution of message printing
(No. 1 to 5)
13.1 Remote Contacts Function
Terminals
2 terminals (EX1, EX2)
4 terminals (EX1 to EX4)
2 terminals (EX1, EX2)
Any 1 terminal
Any 3 terminals
Any 4 terminals
Any 1 terminal
Contact signal at terminal
• Program 3 chart speeds first. See Section 13.3.
Printing on/off and selection
of 3 hart speeds
CS1
Printing: On
CS2
CS3
Printing: Off
(Note) Program "Printing on/off" to on with a key operation in advance.
• Program messages first. See Section 11.10.
Messag
e
EX1
No.1 OFF
No.2 ON
No.3 OFF
No.4 ON
No.5 OFF
* When the trigger signals is sent (for 1 sec. or more) after selecting the
message No., the printing of programmed message starts.
(Note) Program "Printing on/off" to on with a key operation in advance.
Execution of message printing with key operation is also available.
See Section 9.4.
－８７－
Remote contacts terminals
EX1 EX2 EX3 EX4
Remarks
Programming 3 speeds, See Section 13.3. (Note 1)
Programming message, See Section 11.10. (Note 2)
Programming message, See Section 11.10. (Note 3)
Programming operation record, See Section 13.4.
Available in totalization (option)
ON: Short
With COM
EX1
OFF
ON
OFF
ON
With COM
EX2 EX3
OFF OFF
OFF OFF
ON OFF
ON OFF
OFF ON
COM
OFF: Open
EX2
OFF
OFF
ON
ON
EX4*
For trigger
1 sec. or more