Omega RD2800 Series User Manual page 26

5. INSTALLATION
3 Chart Paper Setting
1) Draw out the chart paper approx. 20 cm and
close the rear stripper plate.
2) Set the holes on the chart paper over the
sprockets at both ends of the drum.
3) Use the thumb wheel to advance the chart
paper for 2 to 3 folds into the chart tray.
4) Close the front chart paper guide. Make sure
that the holes are set over the sprockets.
Set the holes on the chart paper to the sprockets.
Remarks
Chart paper folds
Don't insert the chart paper folds reversely
when inserting the chart paper into the chart
paper tray, otherwise a folding failure results.
Folding section
4 Check
1) Manual check
Turn the thumb wheel by hand to make sure
that the chart paper is feeding properly.
5.1 Chart Paper Loading (RD200)
2) Place the chart paper cassette in its original
Place the chart paper cassette with the chart paper
loaded in your recorder.
(1) Guide rails for the chart paper cassette are
(2) Return the keyboard back in its original position.
3) Chart paper feeding check
(1) Turn on the power supply.
(2) Press the
(3) Repeat the above procedure if the chart paper
Chart paper
4) Operation during chart end detection
When the chart paper cassette is returned in the
internal unit during the chart end detection, the
CHART END display blinks. Press
from blinking to steady lighting.
Press
goes out and the chart paper is fed
－２２－
Turning direction of thumb wheel
Remarks
Don't turn the thumb wheel inward. The chart
paper cannot be fed backward. This action
may cause a chart paper feed failure.
Thumb wheel
(Top view)
position
located on the right and left side of the internal
unit. Set the guides of the chart paper cassette to
the guide rails and push it until it clicks into place.
key and check the chart
FEED
paper feeds smoothly.
is not fed smoothly.
again. The CHARD END display
ENTRY
to turn it
ENTRY
automatically.