Units Select
The standard engineering units available on the HHP360 Precision
Absolute Manometer are:
inches of Mercury at 0° C (in Hg @ 0° C)
millimeters of Mercury at 0° C (mm Hg @ 0° C)
PSI
milliBars (mBar)
Bars
kPa
Torr
Feet (Altitude displays)
Meters (Altitude displays)
To change the engineering units the manometer should be "ON"
and in Measure Mode. Then follow these steps:
Keystroke
1. Press the PRGM key.
2. Press the PRGM key.
3.
Press the or
arrow key until
desired engineering
unit is displayed.
4. Press the PRGM key
to select the
engineering unit.
5. Press the arrow
key.
6. Press the PRGM key.
13 of 36
Display
Top line reads "PROGRAM
MODE" and bottom line reads
"UNITS SELECT".
Top line reads "UNITS
SELECT" and bottom line shows
current engineering units.
Engineering units on bottom line
of display change.
Top line reads "PROGRAM
MODE" and bottom line reads
"UNITS SELECT".
Bottom line reads "EXIT".
Display returns to Measure Mode
in new engineering unit.