IBM Flex System p260 Installation And Service Manual page 81

About this task
To remove a DIMM, complete the following steps:
Procedure
1. Read the Safety topic and the "Installation guidelines" on page 35.
2. Shut down the operating system on all partitions of the compute node, turn off the compute node,
and remove the compute node from the IBM Flex System Enterprise Chassis. See "Removing the
compute node from an IBM Flex System Enterprise Chassis" on page 37.
3. Carefully lay the compute node on a flat, static-protective surface, with the cover side up.
4. Open and remove the compute node cover. See "Removing the compute node cover" on page 39.
5. Locate the DIMM connector that contains the DIMM being replaced.
Note: You can use the system-board LEDs and the service label located on the inside of the cover to
identify the DIMM that must be replaced. See "System-board LEDs" on page 17.
Figure 34. DIMM connectors for the IBM Flex System p260 Compute Node
Chapter 6. Installing and removing components
69