IBM Flex System p260 Installation And Service Manual page 78

CAUTION:
When replacing the lithium battery, use only IBM Part Number 33F8354 or an equivalent type battery
recommended by the manufacturer. If your system has a module containing a lithium battery, replace
it only with the same module type made by the same manufacturer. The battery contains lithium and
can explode if not properly used, handled, or disposed of.
Do not:
v Throw or immerse into water
v Heat to more than 100°C (212°F)
v Repair or disassemble
Dispose of the battery as required by local ordinances or regulations.
To install the battery, complete the following steps:
Procedure
1. Follow any special handling and installation instructions that come with the battery.
2. Tilt the battery so that you can insert it into the socket. Make sure that the side with the positive (+)
symbol is facing the correct direction.
3. Press the battery toward the outer wall of the compute node chassis until fully inserted into the
battery holder.
4. Install and close the compute node cover. See "Installing and closing the compute node cover" on
page 41.
Statement 21
CAUTION:
Hazardous energy is present when the compute node is connected to the power source. Always
replace the compute node cover before installing the compute node.
5. Install the compute node into the IBM Flex System Enterprise Chassis. See "Installing the compute
node in an IBM Flex System Enterprise Chassis" on page 93.
6. Turn on the compute node and reset the system date and time through the operating system that you
installed. For additional information, see your operating-system documentation.
7. Ensure that the system time is correct in each of the logical partitions. For additional information, see
the documentation for your operating system.
8. If you replaced the part because of a service action, verify the repair by checking that the amber
enclosure fault LED is off. For more information, see "Compute node control panel button and LEDs"
on page 11.
66
Power Systems: IBM Flex System p260 and p460 Compute Nodes Installation and Service Guide