IBM Flex System p260 Installation And Service Manual page 464

5. Perform the following steps:
Note: When possible, run AIX online diagnostics in concurrent mode. AIX online diagnostics perform
more functions than the stand-alone diagnostics.
a. Perform the AIX online diagnostics, see "Starting AIX concurrent diagnostics" on page 453. Record
any diagnostic results and see the "Service request numbers (SRNs)" on page 301 to identify the
failing component.
Note: When replacing a component, perform system verification for the component. See "Using
the diagnostics program" on page 455.
b. If you cannot perform AIX concurrent online diagnostics, continue to Step 6.
6. Perform the following steps:
a. Ensure that the device from which you load the stand-alone diagnostics is set as the first device in
the compute node boot sequence.
b. Turn off the system unit power and wait 45 seconds before proceeding.
c. Turn on the compute node and establish an SOL session.
d. Check for the following responses:
1) Progress codes are recorded in the event log.
2) Record any messages or diagnostic information that might be in the log.
e. Load the stand-alone diagnostics. Go to "Starting stand-alone diagnostics" on page 453 or
"Starting stand-alone diagnostics from a NIM server" on page 454.
f. If you have replaced the failing component, perform system verification for the component. See
"Using the diagnostics program" on page 455.
This ends the AIX procedure.
7. Perform the following steps:
a. Ensure that the device from which you load the stand-alone diagnostics is set as the first device in
the compute node boot sequence.
b. Turn off the compute node and wait 45 seconds before proceeding.
c. Turn on the compute node and establish an SOL session.
d. Check for the following responses:
1) Progress codes are recorded in the event log.
2) Record any messages or diagnostic information that might be in the log.
Continue with step 8.
8. Load the stand-alone diagnostics. Go to "Starting stand-alone diagnostics" on page 453 or "Starting
stand-alone diagnostics from a NIM server" on page 454.
Can you load the stand-alone diagnostics?
No Go to "Solving undetermined problems" on page 498.
Yes Select the resources to be tested and record any SRNs. Then go to "Service request numbers
(SRNs)" on page 301.
This ends the Linux procedure.
For more information about installing and using all supported operating systems, search the IBM Support
website.
452
Power Systems: IBM Flex System p260 and p460 Compute Nodes Installation and Service Guide