IBM Flex System p260 Installation And Service Manual page 104

Figure 43. Installing the cover for an IBM Flex System p460 Compute Node
Statement 21
CAUTION:
Hazardous energy is present when the compute node is connected to the power source. Always replace
the compute node cover before installing the compute node.
To replace and close the compute node cover, complete the following steps:
Procedure
1. Read the Safety topic and the "Installation guidelines" on page 35.
2. Lower the cover so that the pins on the sides of the cover slide down into the slots (as shown in the
preceding figures) at the front and rear of the compute node. Before you close the cover, verify that all
components are installed and seated correctly and that you have not left loose tools or parts inside the
compute node.
92
Power Systems: IBM Flex System p260 and p460 Compute Nodes Installation and Service Guide