Nortel Secure Network Access Switch; Using The Command Line Interface - Nortel 325 series Cli Manual

4
5
Copyright © 2007, 2008 Nortel Networks
.
Figure 25
Creating a new DHCP scope
Enter a descriptive name to identify the new scope (see
26 "Naming the new DHCP scope" (page
In this example, you are creating a DHCP scope for the Red
VLAN on the Ethernet Routing Switch 8300. The scope start
address for the VLAN is 10.110.110.5 and the end address is
10.110.110.25. The scope you create must have a range of IP
addresses that is large enough to accommodate all endpoint
devices in your network.
Figure 26
Naming the new DHCP scope
Specify the IP address range for the DHCP scope (see
"Specifying the IP address range" (page

Nortel Secure Network Access Switch

Using the Command Line Interface

NN47230-100 03.01 Standard
28 July 2008
Steps 389
Figure
389)).
Figure 27
390)).