Table of Contents
Advertisement
324 Configuring SNMP
Configuring SNMP
To configure SNMP for the Nortel SNAS network, access the SNMP menu
by using the following command:
/cfg/sys/adm/snmp
From the SNMP menu, you can configure and manage the following:
•
•
•
•
•
•
Roadmap of SNMP commands
The following roadmap lists the CLI commands to configure SNMP. Use
this list as a quick reference or click on any entry for more information:
Command
/cfg/sys/adm/snmp
/cfg/sys/adm/snmp/snmpv2-mib
/cfg/sys/adm/snmp/community/cfg/sys
/adm/snmp/community
/cfg/sys/adm/snmp/users <user ID>
Copyright © 2007, 2008 Nortel Networks
.
general settings for SNMP management of the cluster (see
"Configuring SNMP settings" (page
parameters in the standard SNMPv2 MIB (see
v2 MIB" (page
326))
monitor, control, and trap community names (see
SNMP community" (page
SNMPv3 users (see
SNMP managers (see
331))
SNMP monitors and events (see
332))
Nortel Secure Network Access Switch
Using the Command Line Interface
NN47230-100 03.01 Standard
28 July 2008
325))
327))
"Configuring SNMPv3 users" (page
"Configuring SNMP notification targets" (page
"Configuring SNMP events" (page
Parameter
ena
dis
versions <v1 | v2c | v3>
sysContact <contact>
snmpEnable disabled | enabled
read <name>
write <name>
trap <name>
name <name>
seclevel none | auth | priv
permission get | set | trap
authproto md5 | sha
authpasswd <password>
privproto des | aes
"Configuring the SNMP
"Configuring the
328))
Advertisement
Table of Contents
