Nortel Secure Network Access Switch; Using The Command Line Interface - Nortel 325 series Cli Manual

/cfg/sys
followed by:
mip <IPaddr>
host <host ID>
routes
time
dns
rsa <server ID>
syslog
accesslist
Copyright © 2007, 2008 Nortel Networks
.
Sets the MIP for the cluster. The MIP identifies the
cluster and must be unique on the network. For more
information, see
ATTENTION
Nortel does not recommend reconfiguring this
parameter if you are logged on to the MIP, because
you may lose connectivity. To reset the MIP, log on
to the RIP instead.
Accesses the Cluster Host menu, in order to configure
a specific Nortel SNAS host (see
Nortel SNAS host" (page
Accesses the Routes menu, in order to manage static
routes for the cluster when there is more than one
interface (see
Accesses the Date and Time menu, in order to
configure date and time settings and to access
Network Time Protocol (NTP) servers (see
date and time settings" (page
Accesses the DNS Settings menu, in order to manage
DNS servers and tune DNS settings (see
DNS servers and settings" (page
Accesses the RSA Servers menu, in order to configure
the RSA server (see
279)).
ATTENTION
Not supported in Nortel Secure Network Access
Switch Software Release 1.6.1.
Accesses the Syslog Servers menu, in order
to configure the Syslog servers for receiving log
messages (see
279)).
Accesses the Access List menu, in order to control
Telnet and SSH access to Nortel SNAS devices (see
"Configuring the Access List" (page

Nortel Secure Network Access Switch

Using the Command Line Interface

NN47230-100 03.01 Standard
28 July 2008
Configuring the cluster 263
"About the IP addresses" (page
"Configuring the
264)).
"Configuring static routes" (page
274)).
276)).
"Configuring RSA servers" (page
"Configuring syslog servers" (page
273)).
42).
270)).
"Configuring
"Configuring