4
Applying and saving the configuration
You must enter explicit commands in order to make configuration changes
permanent and in order to create a backup configuration file.
If you have not already done so after each sequence of configuration
steps, confirm your changes using the apply command.
To view your configuration on the screen, for copy and paste into a text
file, use the following command:
/cfg/dump
To save your configuration to a TFTP, FTP, SCP, or SFTP server, use the
following command:
/cfg/ptcfg
For more information, see
356).
Copyright © 2007, 2008 Nortel Networks
.
e If you did not run the quick setup wizard during the initial
setup, configure the following:
•
Create the domain (see
•
Create at least one group.
•
Specify the VLANs to be used when the Nortel Health
Agent check succeeds and when it fails (see
extended profiles" (page
Save the configuration (see
configuration" (page
"Backing up or restoring the configuration" (page
Nortel Secure Network Access Switch
Using the Command Line Interface
NN47230-100 03.01 Standard
28 July 2008
Applying and saving the configuration 55
"Creating a domain" (page
164)).
"Applying and saving the
55)).
--End--
83)).
"Configuring