Table of Contents
Advertisement
Add the client ports:
Passport-8310:5# config ethernet 1/16-1/17 nsna dynamic
Enabling NSNA globally
Passport-8310:5# config nsna state enable
Configure the Ethernet Routing Switch 5510
The following configuration example is based on the following
assumptions:
•
•
•
•
•
Steps
To configure the Ethernet Routing Switch 5510 for the Nortel SNAS
network, perform the following steps:
1.
2.
3.
4.
5.
6.
7.
8.
9.
Setting the switch IP address
5510-48T(config)# ip address 10.200.200.20 netmask
255.255.255.0
5510-48T(config)# ip default-gateway 10.200.200.10
Configuring SSH
In this example, the assumption is that the Nortel SNAS public key has
already been uploaded to the TFTP server (10.20.20.20).
Copyright © 2007, 2008 Nortel Networks
.
You are starting with an installed switch that is not currently configured
as part of the network.
You have installed Software Release 4.3.
You have configured basic switch connectivity.
You have initialized the switch and it is ready to accept configuration.
You have configured devices as described to this point.
"Setting the switch IP address" (page 395)
"Configuring SSH" (page 395)
"Configuring the Nortel SNAS pVIP subnet" (page 394)
"Creating port-based VLANs" (page 396)
"Configuring the VoIP VLANs" (page 396)
"Configuring the Red, Yellow, and Green VLANs" (page 396)
"Configuring the login domain controller filters" (page 396)
"Configuring the NSNA ports" (page 396)
"Enabling NSNA globally" (page 397)
Nortel Secure Network Access Switch
Using the Command Line Interface
NN47230-100 03.01 Standard
28 July 2008
Steps 395
Advertisement
Table of Contents
