Next Steps - Nortel 325 series Cli Manual

54 Initial setup

Next steps

Step
1
2
3
Copyright © 2007, 2008 Nortel Networks
.
Setup successful.
login:
Action
To enable the SREM connection to the Nortel SNAS:
a Use the /cfg/sys/adm/ssh on command to enable
SSH access to the Nortel SNAS (for more information, see
"Configuring administrative settings" (page
b Use the /cfg/sys/adm/srsadmin ena command to
enable SRS administration (for more information, see
"Enabling TunnelGuard SRS administration" (page
This is automatically enabled at the time of quick wizard as a
part of configuration management enable.
ATTENTION
For greater security, you may want to restrict access to the Nortel
SNAS to those machines specified in an Access List. In this case,
ensure that you add an IP address for the BBI to the Access List. For
more information about using the Access List to control Telnet and
SSH access, see "Configuring the Access List" (page
From this point on, you can configure the Nortel SNAS using
either the CLI or the BBI.
To enable remote management using Telnet, use the
/cfg/sys/adm/telnet on command to enable Telnet access
to the Nortel SNAS (for more information, see
administrative settings" (page
To finish connecting the Nortel SNAS to the rest of the network,
complete the following tasks:
a Generate and activate the SSH keys for communication
between the Nortel SNAS and the network access devices
(see "Managing SSH keys" (page
b Specify the SRS rule for the nhauser group (see
groups" (page 156)).
c Add the network access devices (see
access devices " (page
d Specify the VLAN mappings (see
66)).
Nortel Secure Network Access Switch
Using the Command Line Interface
NN47230-100 03.01 Standard
28 July 2008
--End--
281)).
"Configuring
281)).
68)).
"Adding a network
60)).
"Mapping the VLANs" (page
284)).
273).
"Configuring