3
4
Copyright © 2007, 2008 Nortel Networks
.
b In a text editor, open the key file.
c Copy the entire contents, including the -----BEGIN
RSA PRIVATE KEY----- and -----END RSA PRIVATE
KEY----- lines.
Add the private key.
a Enter the following command:
/cfg/cert #/key
b Paste the contents of the key file at the command prompt.
c Press Enter to create a new line, and then enter an ellipsis
(...) to terminate.
d If the key is password protected, you are prompted to enter
the password phrase. The password phrase required is the
one you specified when saving or exporting the private key.
Apply the changes.
The certificate and private key are now fully installed.
Figure 17 "Adding a private key by pasting" (page 314)
sample output for the /cfg/cert #/key command. For
more information about the Certificate menu commands, see
"Managing and viewing certificates and keys" (page
Nortel Secure Network Access Switch
Using the Command Line Interface
NN47230-100 03.01 Standard
28 July 2008
Managing private keys and certificates 313
shows
302).