Setting Margins (Margin); Copying With Margins On One Side - Oki MB472dn User Manual

Setting Margins (Margin)

Copying with Margins on One Side

Copying with Margins on Both Sides
The margin function enables you to set margins. This function is useful when you want to staple or punch holes in copies. You can set
the top, bottom, right, and left margins by specifying the [Top] and [Left] values.
Note
A part of a document may not be copied.
The specified margin values stay the same even after you change the zoom rate.
To copy a document in your preferred orientation, specify the orientation in [Direction] in advance.
Changing the Document Orientation (Direction)
Memo
If all the values are set to [0], [Margin] is disabled.
You can set [Margin] as default so that you do not have to set margins every time you make copies.
The value of the margin can be changed from [Admin Setup] > [Copy Setup] > [Default Settings] > [Margin] > [On] > [Margin].
Copying with Margins on One Side
Set margins to a simplex document before copying.
1.
Press (COPY).
2.
Set a document in the ADF or on the document glass.
3.
Press to display the [Change Settings] menu.
4.
Press to select [Margin], and then press
5.
Press to select [ON], and then press
6.
To set the left or right margin, press
.
To create a margin on the left side of the output, specify a positive value.
To create a margin on the right side of the output, specify a negative value.
7.
To set the top or bottom margin, press
(OK).
To create a margin at the top of the output, specify a positive value.
To create a margin at the bottom of the output, specify a negative value.
Memo
You do not need to specify the [Back] margin when copying on a single side.
8.
Press (START).
(OK).
(OK).
and , specify a margin in [Left] of [Front], and then press
and , specify a margin in [Top] of [Front], and then press
42