Oki MB472dn User Manual page 358

Adjusting the Density (Density)
You can adjust the density in seven levels.
1.
Press (FAX).
2.
Set a document in the ADF or on the document glass.
3.
Press to select [Internet Fax], and then press
4.
Press to select [Scan Setting], and then press
5.
Press to select [Density], and then press
6.
Press or
Available density settings
+3, +2, +1,
* indicates the factory default setting.
Memo
[0] is the standard value. To increase the density, select [+1], [+2], or [+3] (darkest). To decrease the density, select [-1], [-
2], or [-3] (lightest).
7.
Specify a destination.
Specify a destination in one of the following ways.
Using Direct Entry
Selecting from the Address Book or Group List
Using a One-touch Key
Selecting from the Transmission History
Specify a Destination by Searching the LDAP Server
8.
Press (START).
Transmission starts.
Topics
You can change other settings for fax transmissions.
Setting Scanning for Transmission
Sending an Internet Fax
to select a value, and then press
0*, -1, -2, -3
(OK).
(OK).
(OK).
(OK).
357