Selecting A Wireless Access Point From The Operator Panel To Connect - Oki MB472dn User Manual

Selecting a Wireless Access Point from the Operator Panel to Connect

If a wireless access point does not support WPS, you can specify a wireless LAN access point you want to use from the wireless LAN
access points that the machine detects to establish a connection. In such a case, you must enter an encryption key.
Set by following the procedure below.
1.
Check the SSID and encryption key by referring to the instruction manual that is included in a wireless
access point or other document, and write the information down.
Memo
An SSID is also called a network name, ESSID, or ESS-ID.
An encryption key is also called a network key, security key, password, or Pre-shared Key.
2.
Check that the wireless LAN access points starts and is operating properly.
3.
Turn the machine on.
Memo
If the following screen is displayed, select [Yes], and then proceed to step 6.
4.
Press (SETTING).
5.
Press to select [Wireless Setting], and then press
6.
Enter the administrator password, select [Enter], and then press
The factory default password is "aaaaaa".
The following message is displayed for approximately 5 seconds.
7.
Press to select [Wireless Network Selection], and then press
The machine starts searching for wireless LAN access points. Wait for a while.
(OK).
(OK).
(OK).
806