Table of Contents
Advertisement
For information about changing the paper size and orientation, refer to "Changing the Paper Size for
Trays 6 and 7 (High Capacity Feeder C2-DS (Optional))" (P.85).
1
Pull out the tray towards you until it stops.
CAUTION
When pulling out the paper tray,
do it slowly. If pulled out with too
much force, the tray can hit and
injure your knees.
Important • While the machine is processing a job, do not pull out the tray that the job uses.
2
Remove any paper loaded in the tray.
3
With the side to be copied or printed on
facing up, load approximately 100 to 500
sheets of paper in the tray and align the
edges of the paper in the arrow direction (1).
Hold the long-side paper guide and slide it to
the desired paper size (2).
Important • When you load tab paper, place the paper
4
With the side to be copied or printed on
facing up, load the remaining paper and
align the edges of the paper in the arrow
direction (1). Hold the short-side paper guide
on the left side and slide it to the desired
paper size of tab paper (2).
Important • Do not load paper exceeding the
5
Push the tray in gently until it stops.
Loading Postcards in Tray 6 or 7 (High Capacity Feeder C2-DS (Optional))
The following describes the procedure for loading postcards in Tray 6 or 7 (High
Capacity Feeder C2-DS (optional)).
Note
For information about changing the paper size and orientation, refer to "Changing the Paper Size for
Trays 6 and 7 (High Capacity Feeder C2-DS (Optional))" (P.85).
• Do not add a new stack of paper on top of the remaining paper in the tray to prevent paper
jams or misloading. Remove any remaining paper from the tray, and then load the removed
paper on top of the newly loaded paper.
with its tab side to the left.
maximum fill line. It might cause paper
jams or machine malfunctions.
• If the number of sheets is 100 or less, the paper guides touch too tightly against the paper,
causing the paper to deform and resulting in paper jams.
• Position the guides correctly to match the paper size. If the position of the guide is not
correct, the paper may not be fed properly, causing paper jams.
• Before loading paper in a tray, fan the paper well. Otherwise, paper jams may occur or
multiple sheets may be fed into the machine at a time.
Loading Paper
4
77
Advertisement
Table of Contents
