Loading Paper In Trays 3 And 4 - Fuji Xerox D125 Quick Reference Manual

1
Pull out the tray towards you until it stops.
CAUTION
When pulling out the paper tray,
do it slowly. If pulled out with too
much force, the tray can hit and
injure your knees.
Important • While the machine is processing a job, do
2
Load and align the edge of the paper against
the left edge of the tray with the side to be
copied or printed on facing down.
Important • Do not load paper exceeding the
3
Push the tray in gently until it stops.
Important • When pushing the paper tray in, do it slowly. If the tray is pushed with too much force, it

Loading Paper in Trays 3 and 4

The following describes the procedure for loading paper in Trays 3 and 4.
Note
For information on changing the paper size and orientation, refer to "Changing the Paper Size for Trays
3 and 4" (P.82).
1
Pull out the tray towards you until it stops.
CAUTION
When pulling out the paper tray,
do it slowly. If pulled out with too
much force, the tray can hit and
injure your knees.
Important • While the machine is processing a job, do
not pull the tray out that the job uses.
maximum fill line. It might cause paper
jams or machine malfunctions.
• Do not add a new stack of paper on top of
the remaining paper in the tray to prevent
paper jams or misloading. Remove any
remaining paper from the tray, and then
load the removed paper on top of the
newly loaded paper.
might cause machine malfunctions.
• Before loading paper in a tray, fan the paper well. It prevents paper from sticking to each
other and reduces paper jams.
not pull the tray out that the job uses.
• Do not add a new stack of paper on top of the remaining paper in the tray to prevent paper
jams or misloading. Remove any remaining paper from the tray, and then load the removed
paper on top of the newly loaded paper.
Loading Paper
4
67