Table of Contents
Advertisement
4 Paper and Other Media
4
With the side to be copied or printed on
facing up, load the remaining paper and
align the edges of the paper in the arrow
direction (1). Hold the short-side paper guide
on the left side and slide it to the desired
paper size of tab paper (2).
Important • Do not load paper exceeding the
5
Push the tray in gently until it stops.
Loading Tab Paper in Tray 6 (A3 High Capacity Feeder (Optional))
The following describes the procedure for loading tab paper in Tray 6 (A3 High
Capacity Feeder (optional)).
4
Important • Tab paper can be used only for [Tab Margin Shift], Covers, and Separators.
Note
For information about changing the paper size and orientation, refer to "Changing the Paper Size for
Tray 6 (A3 High Capacity Feeder (Optional))" (P.83).
1
Pull out Tray 6 towards you until it stops.
When pulling out the paper tray,
do it slowly. If pulled out with too
much force, the tray can hit and
injure your knees.
Important • While the machine is processing a job, do
2
Remove any paper loaded in the tray.
72
maximum fill line. It might cause paper
jams or machine malfunctions.
• If the number of sheets is 100 or less, the paper guides touch too tightly against the paper,
causing the paper to deform and resulting in paper jams.
• Position the guides correctly to match the paper size. If the position of the guide is not
correct, the paper may not be fed properly, causing paper jams.
• Before loading paper in a tray, fan the paper well. Otherwise, paper jams may occur or
multiple sheets may be fed into the machine at a time.
• When a paper jam occurs, the machine outputs unnecessary paper after you have cleared
the paper jam, and resumes copying or printing. For example, you load 5-tab paper and set
[Add Tab Stock] to five. If a paper jam occurs when copying the fourth page, the machine will
automatically output the fifth page and the first page to the third page of the next paper set
after you have cleared the paper jam, and then the machine resumes copying.
• When copying with the [Tab Margin Shift] feature is interrupted, a confirmation screen will
appear on the touch screen after the interrupt mode is exited. Load the tab paper according
to the message.
CAUTION
not pull out the tray that the job uses.
• Do not add a new stack of paper on top of the remaining paper in the tray to prevent paper
jams or misloading. Remove any remaining paper from the tray, and then load the removed
paper on top of the newly loaded paper.
Advertisement
Table of Contents
