Table of Contents
Advertisement
5
Load and align the edge of the paper against
the right edge of the tray with the side to be
copied or printed facing up.
Important • Do not load paper exceeding the
6
Push the tray in gently until it stops.
Note
Changing the Paper Size for Trays 6 and 7 (High Capacity Feeder C2-DS
(Optional))
The following describes how to change the paper size for Trays 6 and 7 (High Capacity
Feeder C2-DS (optional)).
1
Pull out the tray towards you until it stops.
CAUTION
When pulling out the paper tray,
do it slowly. If pulled out with too
much force, the tray can hit and
injure your knees.
Important • While the machine is processing a job, do not pull out the tray that the job uses.
2
Remove any paper loaded in the tray.
3
With the side to be copied or printed on
facing up, load approximately 100 to 500
sheets of paper in the tray and align the
edges of the paper in the arrow direction (1).
Hold the long-side paper guide and slide it to
the desired paper size (2).
4
With the side to be copied or printed on
facing up, load the remaining paper and
align the edges of the paper in the arrow
direction (1). Hold the short-side paper guide
on the left side and slide it to the desired
paper size (2).
Important • Do not load paper exceeding the
maximum fill line. Doing so might cause
paper jams or machine trouble.
• Affix the paper size label to the front of the paper tray.
• Do not add a new stack of paper on top of the remaining paper in the tray to prevent paper
jams or misloading.
maximum fill line. It might cause paper
jams or machine malfunctions.
Changing the Paper Size
M A X
4
85
Advertisement
Table of Contents
