Table of Contents
Advertisement
5
With the side to be copied or printed on
facing up, align the paper stack and load it
into the tray.
Important • Do not load paper exceeding the
6
Push the tray in gently until it stops.
Note
Changing the Paper Size for Tray 6 (A3 High Capacity Feeder (Optional))
The following describes how to change the paper size for Tray 6 (A3 High Capacity
Feeder (optional)).
1
Pull out Tray 6 towards you until it stops.
CAUTION
When pulling out the paper tray,
do it slowly. If pulled out with too
much force, the tray can hit and
injure your knees.
Important • While the machine is processing a job, do
2
Remove any paper loaded in the tray.
3
With the side to be copied or printed on
facing up, load approximately 100 to 500
sheets of paper in the tray and align the
edges of the paper in the arrow direction (1).
Hold the long-side paper guide and slide it to
the desired paper size (2).
4
With the side to be copied or printed on
facing up, load the remaining paper and
align the edges of the paper in the arrow
direction (1). Hold the short-side paper guide
on the left side and slide it to the desired
paper size (2).
Important • Do not load paper exceeding the
maximum fill line. It might cause paper
jams or machine malfunctions.
• Do not place any paper or objects in the
empty space on the right side of Tray 3 or
4. It may cause paper jams or machine
malfunctions.
• Make sure that the paper guide is adjusted to the size of the paper loaded.
• Affix the paper size label to the front of the paper tray.
not pull out the tray that the job uses.
• Do not add a new stack of paper on top of the remaining paper in the tray to prevent paper
jams or misloading.
maximum fill line. It might cause paper
jams or machine malfunctions.
Changing the Paper Size
M A X
83
4
Advertisement
Table of Contents
