Table of Contents
Advertisement
No.
Component
8
Toner cover
9
Tray 1, 2, 3, 4
10
Locking casters
11
Bottom left cover
12
Front cover for high
capacity tray unit
13
Tray 6, 7 (optional)
14
Tray 5 (Bypass)
15
Gigabit Ethernet Board
(optional)
16
10BASE-T / 100BASE-
TX connector
17
USB 2.0 interface
connector
18
Stylus pen
19
Stylus pen holder
20
Ground fault interrupter
Open this cover to replace the toner cartridge.
Load paper here.
Used for locking the wheels of the machine. Lock these casters after moving
the machine to its installation site.
Open this cover to access the inside of the machine to remove jammed
paper.
Open this cover to access the bottom left cover of the machine to remove
jammed paper.
Load paper here.
Used for loading non-standard paper (thick-stock paper, and other special
media) that cannot be loaded in Trays 1 to 4, 6, 7.
Connected to a network cable.
Connected to a network cable. This connector is not available when the
Gigabit Ethernet Board (optional) is installed.
Connected to a USB cable.
Used for touching the touch screen on the control panel to configure
settings.
Note
• You can directly touch the touch screen not only with the stylus pen but
also with a finger.
Stores the stylus pen.
Automatically turns the machine off when a current leakage is detected.
Machine Components
Function
2
15
Advertisement
Table of Contents
